Custom Plate Frames

[bobthetj03]

Sounds good buddy.

[lowranger]

Can he make them with 4 holes for the license plates instead of 2? If so, sign me up for 2 black ones. I will have something else etched on it too.

[JPetru82]

[lowranger]

They hold better and tighter against the off road vehicle and less likely to rattle.

[JPetru82]

ah, makes sense.

[kg6mov]

I'd like one in black. Four hole would be much appreciated as well.

[JPetru82]

From the vendor:

That would depend how many you guys want to order. My minimum for waterjet is 25 and I already have 50 jetted out with the 2 tabs, but if your group wants 25 or more, no problem.

They are actually pretty good with the 2 tabs though (I wheel my FJ pretty hard too), and if they really really wanted to, the slot in the back will accept some foam tape but that was meant more for people with subwoofers, etc

[lowranger]

I definitely want two with the 4 holes. Have seen the bottom of plates snag on things and bend up or broke. He said two holes are "pretty good". I'd like to have " real good ". Hope we can get 25 plates with 4 holes. Thanks for your efforts on this Jeremy!

[JPetru82]

up to 6. Need 19 more if you guys want four holes. Spread the word.

[flyinion]

I might be in depending on what we're putting on it. I'll definitely have to have 4 holes though. The JK's are weird and the stock license plate holder uses only the left holes top & bottom. There's little nubs that go through the right side holes. So if we only have a two hole frame, it's only going to be held on by one bolt.